GPIB0
Bus Timing 500ns
Cable length for high speed disabled
Primary Address 0
Secondary Address None
Terminate read on EOS Yes
Set EOI with EOS on write Yes
8 bit EOS compare No
Send EOI at end of write Yes
EOS byte 10
System Controller Yes
I/O Timeout 10 sec
Parallel Poll duration default
Enable Auto Serial Poll No
Enable CIC Protocol No
Assert REN when SC No
ZEISS0
Primary Address 8
Secondary Address None
Terminate read on EOS Yes
Set EOI with EOS on write Yes
8 bit EOS compare No
Send EOI at end of write Yes
EOS byte 3
I/O Timeout 10 secs
Serial Poll Timeout 1 sec
Enable Repeat Addressing No
ZEISS1
Primary Address 9
Secondary Address None
Terminate read on EOS Yes
Set EOI with EOS on write Yes
8 bit EOS compare No
Send EOI at end of write Yes
EOS byte 10
I/O Timeout 10 secs
Serial Poll Timeout 1 sec
Enable Repeat Addressing No