This registry entry is not used.
These three values define the XYZ location that the system uses as mount points for the slave arm. Mount points are safe locations where the arms move to each time the system starts up. To determine these values, move the ram to the position that you want to use as the mount point for your slave arm and enter the XYZ values to their respective X, Y, and Z registry values.
Entry Name: SlaveMount(XYZ)
Entry Type: Real number that specifies the XYZ mount point locations. The default value is 0.
Common situations when you would use mount points include:
After calibration
Pulling a fixture out
Recovering a column
Calibrating the system
On the slave computer, you need to enter the same values into the master computer's registry entries (MountX, MountY, and MountZ) that you put into the SlaveMountX, SlaveMountY, and SlaveMountZ registry entries.