When you execute your measurement routine, there are steps that you can take that may cause a feature to be in tolerance (PASS) or out of tolerance (FAIL). This is done by clicking Continue in the Execution Mode Option dialog box to PASS the feature or by clicking Skip to FAIL the feature.
If you PASS a feature, the MEAS values for the CENTROID are set to the THEO values.
If you FAIL a feature, the MEAS values for the CENTROID are set to the THEO values + 100mm in the probe vector direction (usually Z). The feature is shown in the Graphic Display window as floating above the part. However, if looking straight down in the Graphic Display window, the feature appears to be drawn correctly.
So, if you have a dimension on the position of the feature, it is in tolerance or out of tolerance depending on whether you clicked Continue or Skip.