Inserting Auto Features

Did you press F1 on the Auto Feature dialog box to get here? See "The Auto Feature Dialog Box" if you want to know what the different components of the dialog box do.

The PC-DMIS configurations that support Auto Features differ in which Auto Features they support as well as how those features are created. Because of this, information on creating and inserting Auto Features into your measurement routine is not covered here. Instead, consult the documentation set for your PC-DMIS configuration from the list below:

Contact (PC-DMIS CMM)	Vision (PC-DMIS Vision)	Laser (PC-DMIS Laser)
Auto Vector Point
Auto Surface Point	Auto Surface Point	Auto Surface Point
Auto Edge Point	Auto Edge Point	Auto Edge Point
Auto Angle Point
Auto Corner Point
Auto High Point
Auto Line	Auto Line
Auto Plane		Auto Plane
Auto Circle	Auto Circle	Auto Circle
Auto Ellipse	Auto Ellipse
Auto Square Slot	Auto Square Slot	Auto Square Slot
Auto Round Slot	Auto Round Slot	Auto Round Slot
Auto Notch Slot	Auto Notch Slot
Auto Polygon	Auto Polygon	Auto Polygon
Auto Cylinder		Auto Cylinder
Auto Cone		Auto Cone
Auto Sphere		Auto Sphere
		Auto Flush and Gap
Probe Toolbox Information
Contact Probe Toolbox	Vision Probe Toolbox	Laser Probe Toolbox

Once an Auto Feature is created, its command appears inside the Edit window (see "Auto Feature Field Definitions"). You can then mark the command and have PC-DMIS execute it like any other command or feature.