Constructing New Features from
Existing Features
Constructing
New Features from Existing Features: Introduction
Understanding
the General Command Format
Specifying Feature Theoreticals
Constructing a Point Feature
Constructing a Line Feature
Constructing a Plane Feature
Constructing a Circle Feature
Constructing an Ellipse
Feature
Constructing a Round
Slot Feature
Constructing a Square
Slot Feature
Constructing a Curve
Constructing a Cylinder
Feature
Constructing a Cone Feature
Constructing a Sphere Feature
Constructing a Surface
Constructing a Set of Features
Constructing a Filter Set
Constructing an Adjusted
Filter
Constructing a Width Feature