Following are TNT and PCiia card settings.
GPIB0
Parameter |
Setting |
Bus Timing |
500 ns |
Cable Length for High Speed |
Disabled |
Primary Address |
0 |
Secondary Address |
None |
Terminate Read on EOS |
Yes |
Set EOI with EOS on Write |
Yes |
8 Bit EOS Compare |
No |
Send EOI at End of Write |
Yes |
EOS Byte |
3 |
System Controller |
Yes |
I/O Time-out |
10 sec |
Parallel Poll Duration |
Default |
Enable Auto Serial Poll |
Yes |
Enable CIC Protocol |
No |
Assert REN when SC |
No |
CNTRLW
Parameter |
Setting |
| Primary Address | 9 |
| Secondary Address | None |
| Terminate Read on EOS | Yes |
| Set EOI with EOS on Write | Yes |
| 8 Bit EOS Compare | No |
| Send EOI at End of Write | Yes |
| EOS Byte | 3 |
| I/O Time-out | 3 secs |
| Serial Poll Time-out | 3 msec |
| Enable Repeat Addressing | Yes |
CNTRLR
Parameter |
Setting |
| Primary Address | 8 |
| Secondary Address | None |
| Terminate Read on EOS | Yes |
| Set EOI with EOS on Write | No |
| 8 Bit EOS Compare | No |
| Send EOI at End of Write | No |
| EOS Byte | 3 |
| I/O Time-out | 3 secs |
| Serial Poll Timeout | 1 sec |
| Enable Repeat Addressing | Yes |