Command Identification - IDLength

This registry entry determines the length of the identification for the various commands. The valid values for the length are from 0 to 15. If you set this length, PC-DMIS appends zeros to the ID letters to make up the necessary length.

ID Length = 10, ID Letters = CIRCLE. PC-DMIS generates an ID = CIRCLE0001, etc. This is done only if the length is set.

Entry Name: A,C,COPOper,CS,D,FCF,F,L,Q,V)Length(0-17)

Entry Type: Whole number that specifies the number of digits. The default value is 0.

Preferably, this value should be set on the ID Setup tab in the Setup Options (F5) dialog box in PC-DMIS.

Command Key

Command

Type

ALength0

Alignments

CLength0

Comments

COPOperLength0

Pointcloud Operator

CSLength0

Call Subs

DLength(0-16)

Dimension/Angle - Symmetry

FCFLength(0-16)

Feature Control Frame

FLength(0-17)

Feature/Blobs - Surfaces

LLength0

Label

QLength0

SPC Queries

VLength0

Variables

See Also:

Command Identification - ID Letters

Command Identification - ID Starting Number