All generic features have XYZ and IJK values. They may have ANGLE, DIAMETER, RADIUS, or DISTANCE values depending on the type assigned to the feature.
The Nominal / Measured Values toggle button indicates the values that are used in the generic feature.
The command line in the Edit window (a cone is shown) is as follows:
feature_name=GENERIC/TOG1,TOG2, TOG3, TOG4
NOM/XYZ,x_cord,y_cord,z_cord
MEAS/XYZ,x_cord,y_cord,z_cord
NOM/IJK,i_cord,j_cord,k_cord
MEAS/IJK,i_cord,j_cord,k_cord
[RADIUS/radius] | [DIAMETER/diameter]
[ANGLE/ang]
[DISTANCE/dist]
TOG1 =POINT, PLANE, LINE, CIRCLE, SPHERE, CYLINDER, CONE, SLOT, or NONE
TOG2 = Indicates whether the generic feature is alignment dependent or independent.
TOG3 = Indicates whether the feature uses Polar or Rectangular coordinates.
TOG4 = Indicates whether the feature is an IN (hole) or OUT (stud) feature.
[ ] = The options shown in brackets are discretionary and are available based on the type assigned to the feature by TOG1. RADIUS and DIAMETER are mutually exclusive representations for the value represented as the radius or the diameter.