These values determine the order that the specified option is displayed as part of a Dimension command.
Entry Name: DimInfo(option)OrderDefault
Entry Type: Whole number that specifies the order. The default value is 0.
Options Key
Option |
Description |
DimInfoDeviationOrderDefault |
Deviation of the measured value from the nominal |
DimInfoLocAOrderDefault |
Location Angle (for cones) |
DimInfoLocDOrderDefault |
Location Diameter |
DimInfoLocFOrderDefault |
Location Integrated Form Dimension |
DimInfoLocHOrderDefault |
Location Height |
DimInfoLocLOrderDefault |
Location Length (used for cylinders, slots, cones, and ellipses) |
DimInfoLocPAOrderDefault |
Location Polar Angle |
DimInfoLocPDOrderDefault |
Location Diameter of a Circle (perpendicular to the pin vector) |
DimInfoLocPROrderDefault |
Location Polar Radius |
DimInfoLocROrderDefault |
Location Radius |
DimInfoLocRSOrderDefault |
Location Deviation along a surface report |
DimInfoLocRTOrderDefault |
Location Deviation along the Report vector |
DimInfoLocSOrderDefault |
Location Deviation along the Surface vector |
DimInfoLocTOrderDefault |
Location Error along approach vector (for points on curved surfaces) |
DimInfoLocVOrderDefault |
Location Vector |
DimInfoLocXOrderDefault |
Location X Axis |
DimInfoLocYOrderDefault |
Location Y Axis |
DimInfoLocZOrderDefault |
Location Z Axis |
DimInfoMaxminOrderDefault |
Maximum and minimum values for the dimension |
DimInfoMeanOrderDefault |
Average of all the deviations for the dimension |
DimInfoMeasuredOrderDefault |
Actual measured dimensions |
DimInfoNominalOrderDefault |
Theoretical values for the dimension |
DimInfoNumpointsOrderDefault |
Number of points used to measure the feature of the dimension |
DimInfoOuttolOrderDefault |
Out of tolerance measured value from the nominal and tolerance values |
DimInfoStddevOrderDefault |
Standard deviation of all the deviations for the dimension |
DimInfoToleranceOrderDefault |
Acceptable tolerance levels either greater than or less than the nominal |
DimInfoTPD1OrderDefault |
True Position diameter/width value of the first datum |
DimInfoTPD2OrderDefault |
True Position diameter/width value of the second datum |
DimInfoTPD3OrderDefault |
True Position diameter/width value of the third datum |
DimInfoTPDFOrderDefault |
True Position diameter of Feature |
DimInfoTPFormOrderDefault |
True Position integrated form dimension for the feature |
DimInfoTPPAOrderDefault |
True Position polar angle |
DimInfoTPPROrderDefault |
True Position polar radius |
DimInfoTPTPOrderDefault |
True Position Tolerance |
DimInfoTPXOrderDefault |
True Position X Axis |
DimInfoTPYOrderDefault |
True Position Y Axis |
DimInfoTPZOrderDefault |
True Position Z Axis |