SP6MTX Registry Entries for ANALOG_PROBING

You must use the PC-DMIS Settings Editor to modify the SP6MTX registry entries. The software obtains these values after you complete the SP600 Lower Level Matrix calibration. PC-DMIS uses the values to create force variations needed to accurately obtain the low level matrix numbers for your probe.

For information on how to perform a lower level matrix calibration, see the "Contact Scanning Probe Calibration Procedures" topic in the "Setting Up and Using Probes" chapter of the PC-DMIS CMM documentation.

More:

SP6MTX Lower Force

SP6MTXLowerForce_LSPX1C

SP6MTXLowerForce_LSPX1M

SP6MTXLowerForce_LSPX1S

SP6MTXLowerForce_LSPX3

SP6MTXLowerForce_LSPX5

SP6MTXLowerForce_SP600

SP6MTXLowerForce_SP80

SP6MTX Max Force

SP6MTXMaxForce_LSPX1C

SP6MTXMaxForce_LSPX1M

SP6MTXMaxForce_LSPX1S

SP6MTXMaxForce_LSPX3

SP6MTXMaxForce_LSPX5

SP6MTXMaxForce_SP600

SP6MTXMaxForce_SP80

SP6MTX Upper Force

SP6MTXUpperForce_LSPX1C

SP6MTXUpperForce_LSPX1M

SP6MTXUpperForce_LSPX1S

SP6MTXUpperForce_LSPX3

SP6MTXUpperForce_LSPX5

SP6MTXUpperForce_SP600

SP6MTXUpperForce_SP80