During Auto feature creation, PC-DMIS takes properties from the Measurement Strategy Editor (MSE) if it detects a probe type change or a program mode (Manual / DCC) change. With these entries, PC-DMIS can tell if the probe type or probe mode changed, even if you exit PC-DMIS. This means the software no longer always takes the properties from the MSE.
These entries keep track of the last probe type used to create the Auto feature. This helps PC-DMIS know if it should take the properties from the MSE or from the entry values.
This topic represents many entries where <Type> is the feature type. These are for tactile features. The entries store the probe type PC-DMIS used for that feature type. These entries let PC-DMIS know where to get the properties from during future feature creations:
Entry Names:
LastInjectedProbeType_Angle Point, LastInjectedProbeType_Circle,
LastInjectedProbeType_Cone, LastInjectedProbeType_Corner Point,
LastInjectedProbeType_Edge Point, LastInjectedProbeType_Ellipse,
LastInjectedProbeType_Flush and Gap, LastInjectedProbeType_High Point,
LastInjectedProbeType_Line, LastInjectedProbeType_Notch Slot,
LastInjectedProbeType_Plane, LastInjectedProbeType_Polygon,
LastInjectedProbeType_Round Slot, LastInjectedProbeType_Square Slot,
LastInjectedProbeType_Surface Point, LastInjectedProbeType_Vector Point
Entry Type: Integer of 0 (default), 1, 2, 4, 8, 16, 64, or 128.
0 = PT_NONE
1 = PT_CONTACT_FIXED
2 = PT_CONTACT_TOUCHTRIGGER
4 = PT_CONTACT_ANALOGUE
8 = PT_NONCONTACT_VISION
16 = PT_NONCONTACT_LASER_STRIPE
64 = PT_NONCONTACT_LASER_SPOT
128 = PT_PLANNER