This value sets and uses the minimum edge strength for a detected edge point. This value is only used for vision Probe Offset calibration. The data discrimination for edge strength occurs at a low level as PC-DMIS collects each point from the sensor, in this case the image processing. Points whose strength is too low are not passed up to the parent feature, such as a circle, for further processing, fitting, filtering, etc.
See the "Strength" value of the "Automatic Hit Target - Edge Parameter Set" topic in the PC-DMIS Vision documentation.
Entry Name: ProbeQualVisionEdgeStrength
Entry Type: Whole number that specifies edge strength. The default value is 4.