UseSizeForProfileDimension

This entry was added in PC-DMIS version 4.3 MR2 and later. It lets you revert to the PC-DMIS version 4.2 and earlier behavior for legacy profile dimensions only.

However, note that the FCF profile dimensions always take the size of the feature or surface/curve into consideration even when this entry is set to 0. Unless, the GD&T Standard is set to ISO 1101 (if the UseISOCalculations entry is set to 1).

Entry Name: UseSizeForProfileDimension

Entry Type: Whole number of 0 or 1. The default value is 1.