Both the SLC and VisionBox interfaces use the CWS.ini file. For information, on how to install this file, see the "CWS.INI Installation Instructions" topic.
This topic is for the FDC-VisionBox Interface.
Section |
Key |
Default Value |
Type of Value |
Description |
COM |
DEBUG |
0 |
Integer |
This value determines if enable debugging is on or off: Off = 0 On = 1 |
COM |
Connected |
0 |
integer |
This value determines if the application connects to the device or not: No = 0 Yes = 1 |
COM |
Port |
7 |
integer |
This value sets the serial port number for CWS. |
COM |
Baudrate |
115200 |
integer |
This value is the USB connection speed (CHRocodile requires 921600). |
GRAPHIC |
Zero |
50.0 |
Double |
This value is the offset position [%] in the measurement range. |
CONFIG |
SensorHeadNo |
0 |
Integer |
This value is the sensor head number to use at startup. |
CONFIG |
ForceSensorHeadNo |
0 |
Integer |
This value determines if you can set the sensor head from within the application or if the application only uses the value set in the SensorHeadNo settings entry key: 0 = This value allows you to set the sensor head from the application (for example, with TKJ-OMM). 1 = This value forces the application to always uses the sensor head number defined by the SensorHeadNo in the CWS.ini file. The application cannot set the sensor head number. |
CONFIG |
CHECKSINGLEVALUES |
1 |
integer |
This value determines if the validation of single point measurement raw result is on or off: Validation Off = 0 Validation On = 1 |
Debug |
FileTrace.System.Commands |
0 |
integer |
This value sets the log CWS system commands in HMV debug files on or off: Off = 0 On = 1 |
In the case of the CHRocodile 2SHS, the COM settings for Port, Baudrate, Parity, Databits, Stopbits, and Handshake are not relevant since this controller requires an Ethernet connection (IP = 192.168.170.2, port = 7891).