To set the values for the FDC-SLC
interface entries, use the PC-DMIS Settings Editor.
Laser (CWS or TTL) require different setups. For CWS, you need to set these
entries:
| Setting Entry | Default Value | Settings Editor Section |
| CWSPresent | True | FDC |
| Laser_Type | 2 | MSI |
For TTL, you need to set these entries:
Setting Entry |
Default Value | Settings Editor Section |
| FLSPresent | True | FDC |
| Laser_Type | 1 | MSI |
If you install a rotary table, you need to set these additional settings:
Setting Entry |
Default Value | Settings Editor Section |
| EnableRotaryAbsolutePosition | True | FDC |
| EnableRotaryClockMode | True | FDC |
| SendHSSFullData | 2 | FDC |
| RotaryMinDelta | 0.05 | FDC |
| RotaryOffset | 0 | FDC |
| RotaryOffsetSpeed | 50 | FDC |
| RotaryTablePresent | True | FDC |