Paste With Pattern - Non Curve Procedure

To create a non-curve pattern, follow this procedure:

1. Define the Auto feature, features, and other commands that you want to paste, and then copy them to the Clipboard. If you want to copy and paste one or more Auto features and want to use a predefined clearance plane, make sure that you have set CLEARPLANE=ON inside the Auto features you are copying.

2. Choose Edit | Pattern to open the Pattern Setup dialog box.

3. Access the Alignment tab and type the desired offset values in the Offset area. If you're doing an angle pattern, type an angle offset, and then click on the center hole to get the values for the Center of Rotation area.

4. If you want to mirror the axis, select the desired option from the Mirror area.

5. Type the number of times to offset in the Number of times to offset box.

6. Mark Apply "Paste With Pattern" on OK.

7. Click OK to store the definition and to paste the defined pattern.