Adding Lines

To add a line, do the following:

1. Place the cursor in the desired location and press the Enter key.

2. Type the word ALIGNMENT.

3. Press the Tab key.

PC-DMIS adds the new line depending on where the cursor is located:

• If the cursor is in the middle of a command, PC-DMIS creates a new line below the current line.

• If the cursor is placed at the beginning of a command line, PC-DMIS places the new line above the current cursor position.

The first new line always displays the minor command: LEVEL. To easily change this, enter a new command. Additional lines that you create after the initial line display the most recent command.