You can see what the LK software sends to its controllers by enabling its communications log. To turn on the communications log for any application that uses LKCMM.CFG, you can also edit the file.
This topic describes how to turn on the LK's communications log in the LK-DMIS software.
When you start the program, the Non Programmed Inspection Dialog box appears.
Click the Utilities button.
Click the Machine button.
Click the Config button.
Click OK when the warning message appears.
Select the Diagnostics tab.
Select the Controller communications log enabled check box. Enter a file name in the box below it, or use the default entry (usually comms.log).
From here, you can review the settings in the LKCMM.CFG file. The settings of interest are the “Default” settings.
Click OK.
Click Close, and then Close again.