This entry determines the boundary type that creates an imaginary feature that acts as a boundary around a scan's end point. By default, this feature is a plane at the end point that when crossed one time stops the scan.
Entry Name: ScanDialogBoundaryType
Entry Type: Whole number that specifies the number for the boundary type. The default value is 0.
Boundary type key:
Value |
Type |
Description |
0 |
Plane |
The scan will stop after the probe crosses the plane at the end point the given number of times. |
1 |
Sphere |
The scan will stop after the probe crosses (breaks) the sphere at the end point the given number of times. |
2 |
Cylinder |
The scan will stop after the probe crosses (breaks) the cylinder at the end point the given number of times. The cylinder is considered infinite in length. |
3 |
Cone |
The scan would stop after the probe crosses (breaks) the cone at the end point the given number of times. The cone is considered infinite in length. |
4 |
Oldstyle |
(This value is retained for backwards compatibility.) |