Based on the feature type and the part material type, adjust the following values according to the table below:
The Exposure value found on the Laser Scan Properties tab
The Min and Max Gray Sum values found on the Laser Pixel CG Locator Properties tab
Exposure and Gray Sum Settings |
||||
Feature Based |
||||
Feature |
Material |
Exposure |
Min Gray Sum |
Max Gray Sum |
Sphere | Tungsten Calibration Sphere | 120 | 10 | 300 |
Ceramic | 80 | 10 | 300 | |
Gap/Flush | Sheet Metal | 150 | 30 | 300 |
White | 100 | 30 | 300 | |
Blue | 120 | 30 | 300 | |
Black | 450 | 10 | 300 | |
Circle | Sheet Metal | 100 | 50 | 300 |
White | 100 | 50 | 300 | |
Blue | 120 | 50 | 300 | |
Black | 450 | 30 | 300 | |
Aluminum | 80 | 50 | 300 | |
Slot | Sheet Metal | 100 | 50 | 300 |
White | 100 | 50 | 300 | |
Blue | 120 | 50 | 300 | |
Black | 450 | 30 | 300 | |
Aluminum | 80 | 50 | 300 | |
Edge Point | Sheet Metal | 100 | 50 | 300 |
White | 100 | 50 | 300 | |
Blue | 120 | 50 | 300 | |
Black | 450 | 30 | 300 | |
Aluminum | 80 | 50 | 300 | |
Plane | Sheet Metal | 100 | 30 | 300 |
White | 100 | 30 | 300 | |
Blue | 120 | 30 | 300 | |
Black | 450 | 10 | 300 | |
Aluminum | 80 | 30 | 300 | |
Surface Point | Sheet Metal | 100 | 30 | 300 |
White | 100 | 30 | 300 | |
Blue | 120 | 30 | 300 | |
Black | 450 | 10 | 300 | |
Aluminum | 80 | 30 | 300 |