You can use the CW43L 3rd Axis Continuous C Joint with and without the CW43L probe changer.
If you are using the Continuous C Joint with the probe changer, you must set the following entries:
HasContinuousCJoint
0 – If the third axis is in the probe changer.
1 – If the third axis is on the arm.
CW43LThirdAxisTCSlot = Port number
If you are not using the CW43L probe changer, and you are using a Continuous C Joint, you must set the following entries:
HasContinuousCJoint = 1
CW43LThirdAxisTCSlot = -1
For more information, see "Interface-Specific Options".