Modified decryption method to support x64 (PCD-104300).

Added support for the new LK jog box (PCD-104301).

Fixed issue when relative speed was too small, touch mode fails in Jog Box Fast mode (PCD-25627).

Added additional check for machine move start.

Corrected circular move response for machines that send multiple responses for one fly move.

Added support for Fly Mode.

Fixed problem where Auto-Slot was taking double hits.

Fixed issue where VNass-Numerous was hanging (PR# 273888).

Added checks for Superfluous 'G' when responses arrived together.

Removed response requirement for Manual Hit Clear.

Final fix for Bosch circular moves. Tested on site at Draexlmaier (PR# 273745).

Fixed bug that missed response when two responses were returned together.

Fixed bug with relative moves that did not consider retracts position (PR# 272635).

Fixed bug occurring with large circular moves (PR# 272245).

Fixed for hit vector not recognized due to non-conversion from inches (PR# 272669).

Fixed for "Tool not Armed" error after probe change.

Corrected long delay at start of execution due to queued goManual commands.

Corrected speed calculation.

Added flag for support of controllers requiring only a single response for circular moves.

Added support for MCC-200 (TPC) controller.

Fixed problem with Find Hole.

Corrected DCC retract use of wrong param ID.

Improved error handling.

Added option to disable "Print" as END key from jog box.

Initial release for IP-based LK scanning CMMs.