This probe changer requires no RS-232 communications port.
These are the available entries for this interface:
[ZEISS]
TCDepthClearance = 75.0
TCVerticalClearance = 7
TCVerticalStroke = 10
You can select this probe changer from the Probe Changer dialog box.
This probe changer is typically used on Zeiss machines with an ST2 or ST3 switching probe head. This probe changer is not applicable to all interfaces. See the specific section for the Zeiss interfaces for more information about whether a particular interface supports it, as well as other setup parameters in the interface-specific portion of PCDLRN.INI.
Note that these values were used with older versions of PC-DMIS (for example, version 2.X).