This is standard CMM data output that is similar to a PC-DMIS measurement routine. See "CMM Report (CMM) Sorted by Calc" for an example of this file sorted by calculation.
For more information about this option, see "Setting Reporting Options".
!******* Start of Example CMM File ******************
Report from Y:\BladeRunner\blades\1234\1234.rpt
SERNO = 1
OPERATION = TEST
CMM = BROWNSHARPE
PARTCOUNT = 1
Actual Nominal Deviation +Tol -Tol OutTol
Section B-B
LE THICK 0.2860 0.1804 0.1056 0.0139 -0.0137 0.0917
TE THICK 0.2108 0.1191 0.0917 0.0198 -0.0290 0.0719
MAX THICK 1.0895 0.9634 0.1262 0.0325 -0.0327 0.0936
CHORD WID 7.0645 6.9211 0.1434 0.0620 -0.0762 0.0814
TWIST ANG -0.0117 0.0000 -0.0117 0.2500 -0.2500 ----*----
SHIFT -0.0014 0.0000 -0.0014 0.0064 -0.0064 ---*-----
SHIFT 0.0040 0.0000 0.0040 0.0064 -0.0064 -------*-
Section D-D
LE THICK 0.2282 0.1135 0.1148 0.0078 -0.0078 0.1069
TE THICK 0.1772 0.0774 0.0997 0.0090 -0.0212 0.0908
MAX THICK 0.7394 0.6107 0.1286 0.0202 -0.0202 0.1085
CHORD WID 7.0472 6.9154 0.1318 0.0677 -0.0705 0.0641
TWIST ANG -0.0367 0.0000 -0.0367 0.2500 -0.2500 ---*-----
SHIFT -0.0018 0.0000 -0.0018 0.0189 -0.0189 ----*----
SHIFT -0.0051 0.0000 -0.0051 0.0189 -0.0189 ---*-----
Section F-F
LE THICK 0.1788 0.0525 0.1263 0.0060 -0.0060 0.1203
TE THICK 0.1235 0.0372 0.0864 0.0027 -0.0113 0.0836
MAX THICK 0.4111 0.2842 0.1269 0.0094 -0.0094 0.1175
CHORD WID 7.0324 6.9143 0.1181 0.0688 -0.0694 0.0493
TWIST ANG -0.0301 0.0000 -0.0301 0.2500 -0.2500 ---*-----
SHIFT 0.0050 0.0000 0.0050 0.0200 -0.0200 -----*---
SHIFT -0.0136 0.0000 -0.0136 0.0200 -0.0200 -*-------
!******* End of Example CMM File ******************