) - This imports
GD&T callouts embedded in your CAD model. For more information on
this option, see "Using
GD&T Selection Mode (from CAD)".PC-DMIS provides these ways to get Feature Control Frames (FCFs) into PC-DMIS from GD&T tolerances in other sources:
GD&T
Selection Mode (from CAD) () - This imports
GD&T callouts embedded in your CAD model. For more information on
this option, see "Using
GD&T Selection Mode (from CAD)".
GD&T
Selection Mode (from Capture) (
) - This opens
Snipping Tool from your operating system so that you can manually capture
a single GD&T tolerance from a drawing. PC-DMIS uses Optical Character
Recognition (OCR) to convert a GD&T tolerances to a FCF. For more
information on this option, see "Using
GD&T Selection Mode (from Capture)". In the process, PC-DMIS
creates the commands for any datums and considered features. For more
information, see "About Optical Character Recognition" below.
GD&T
Selection Mode (from File) (
) - This is similar
to the "from Capture" option above, except that PC-DMIS lets
you open a drawing and decide what GD&T tolerances to import using
Optical Character Recognition (OCR). The software then cycles through
each GD&T tolerance on the drawing. For information on this option,
see "Using GD&T
Selection Mode (From File)". For more information, see "About
Optical Character Recognition (OCR) to Create FCFs" below.
These toolbar icons are available on the Graphic Modes toolbar and the QuickMeasure toolbar. For information about toolbars, see the "Using Toolbars" chapter.
More:
Using GD&T Selection Mode (from CAD)
Using GD&T Selection Mode (from Capture)