To create an additional line within the location dimension, do the following:
Place the cursor in the desired location.
Press the Enter key.
Type in the desired axis (X, Y, Z, D, R, A, V, T, L, S, H, M, PR, PA, PD).
Press the Tab or Enter key.
PC-DMIS then displays the values for the added axis. PC-DMIS adds the new line depending on where the cursor is located. If the cursor is in the middle of a command, a new line is created below the current line. If the cursor is placed at the beginning of a command line, PC-DMIS creates the new line above the current cursor position.