Before you use PC-DMIS with your laser device, the basic steps below can help you verify that your system is properly prepared.
The M&H LS-R laser sensor is currently for offline use only and doesn't require any setup procedures. You can find information on this sensor in the "M&H LS-R Laser Sensor" section of the PC-DMIS Laser documentation.
To get PC-DMIS running with your laser sensor, follow these steps:
If you are using a Perceptron laser on a Romer arm, see the "Using a Romer Portable CMM" section of the PC-DMIS Portable documentation.
Starting with PC-DMIS 2019 R2, PC-DMIS no longer supports the Perceptron laser sensor. While you may still be able to install PC-DMIS 2019 R2 and later, PC-DMIS displays an error if you attempt to run measurement routines that use the Perceptron scanner. For additional information, please contact Technical Support.