Send Topic Feedback | See Object Hierarchy Chart
PC-DMIS 2023.2 Object Library
PCDLRN ActiveX DLL : PCDSTARTFEATFLAGS Enumeration
PCDSTARTFEATFLAGS Enumeration
Members
MemberValueDescription
PCD__BACK5 
PCD__BOTTOM1 
PCD__EXTERIOR0Exterior angle hit. Only used for auto angle hits. Do not or with PCD_INTERIOR. Default.
PCD__FRONT4 
PCD__INTERIOR8Interior angle hit. Only used for auto angle hits. Should not be combined with PCD_EXTERIOR.
PCD__LEFT2 
PCD__RECALC_NOMS65536Indicates that the theoretical values should be recalculated based on the theoretical hit values.
PCD__RIGHT3 
PCD__TOP0 
PCD__XAXIS2 
PCD__XMINUS3 
PCD__XPLUS2 
PCD__YAXIS4 
PCD__YMINUS5 
PCD__YPLUS4 
PCD__ZAXIS0 
PCD__ZMINUS1 
PCD__ZPLUS0 
PCD_ANGLE256Cone reports its angle as opposed to length. Should not be combined with PCD_LENGTH.
PCD_AUTOMOVE131072Causes move points to be automatically generated for auto features.
PCD_BND512Bound line. Should not be combined with PCD_UNBND.
PCD_FINDHOLE262144For Auto Circles. Automatic finding of holes.
PCD_HEM4096For auto edge points only. Should not be ored with PCD_TRIM.
PCD_IN128Inside circle, sphere, cone, or cylinder. Should not be combined with PCD_OUT.
PCD_LENGTH0Cone reports its length as opposed to angle. Do not or with PCD_ANGLE. Default.
PCD_LINE_3D327683D line. Used only for best fit lines. Default is a 2D line.
PCD_MEASURE_BOTH2048Sets measure order. For auto edge points only.
PCD_MEASURE_EDGE1024Sets measure order. For auto edge points only.
PCD_MEASURE_SURFACE0Sets measure order. For auto edge points only. Default.
PCD_MEASURE_WIDTH524288Flag for Auto Square Slots.
PCD_NORM0For auto circles, cylinders, ellipses, and slots. Do not combine with PCD_PIN. Default.
PCD_OUT0Outside circle, sphere, cone, or cylinder. Should not be used with PCD_IN. Default.
PCD_PIN8192For auto circles, cylinders, ellipses, and slots. Do not or with PCD_NORM.
PCD_POLR64Values are reported in cylindrical coordinates. Should not be combined with PCD_RECT.
PCD_READPOS16384Turn read position on. For auto circles, cylinders, ellipses, and slots. Defaults to off.
PCD_RECT0Values are in rectangular coordinates. Should not be combined with PCD_POLR. Default.
PCD_TRIM0For auto edge points only. Should not be ored with PCD_HEM. Default.
PCD_UNBND0Unbound line. Should not be ored with PCD_BND. Default.