How To Calibrate Probe Length
Instructions | ||||
|---|---|---|---|---|
1 | Press the Set Probe Length button. |
| ||
2 | Enter the expected target value for the point.
| |||
3 |
| Position the probe over the target value and press the Execute button. | ||
4 |
| Review the measured data and press OK. | ||
Additional Notes
It is recommended that you calibrate the probe length before you perform a calibration on the sphere. This allow you to use the Find Sphere function to determine the location of the calibration sphere (including the Z location).
It is important to use a well-known and well-defined surface to set the probe length.